Puremax SX Mini Vape Kits

Despite of me following the instructions it started to leak from day one unfortunately. If I was able to collect all the leaked juices out of it I could fill more than half of a 10ml vape liquid bottle. Also I found the lid for re-filling hole a bit flimsy. Whenever I wanted to remove the container cartridge from the device to clean leaked vape juices that lid would slide up open. My solution for it was to use a small piece of sellotape to secure the lid in place first then slide the cartridge in so whenever I needed to take the cartridge refilling lid could stay in place after wiping off leaked liquids I would remove the sellotape, slide open the lid, tilt the cartridge towards the mouthpiece then top up with liquid no more than 10 seconds, close the lid then secure it with a single layer small piece of sellotape, create vacuum in the container by sucking the air out of mouth piece then quickly install it back into the device. Once the device had more juice in it than the cartridge itself I dismantled the device cleaned it using paper towel. Put everything together whilst making sure that the plastic/silicone sealant ring sits exactly where it should and correct side up. also installed very thin O ring in place. Filled the container "again" with the hope that it wouldn't leak again. I enjoyed vaping it rest of the evening but next morning there was yet again leaked juice was around where I left it. I would fully close the air inlet in order to maintain the vacuum in the cartridge when I wasn't using it. Don't want to waste anymore e-liquid on it stopped using the device completely. Sorry it was a long text but if I cut it short people would think either I didn't use it right or left something untried before giving up on this product.